 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| UTC TL074 LINEAR INTEGRATED CIRCUIT LOW NOISE QUAD J-FET OPERATIONAL AMPLIFIER DESCRIPTION The UTC TL074 is a high speed J-FET input quad operational amplifier. It incorporates well matched, high voltage J-FET and bipolar transistors in a monolithic integrated circuit. The device features high slew rates, low input bias and offset current, and low offset voltage temperature coefficient. SOP-14 FEATURES *Low power consumption *Wide common-mode (up to vcc+ ) and differential voltage range *Low input bias and offset current *Low noise en = 15nV / Hz(typ) *Output short-circuit protection *High input impedance J-FET input stage *Low harmonic distortion:0.01%(typ) *Internal frequency compensation *Latch up free operation *High slewrate:13V/s(typ) DIP-14 PIN CONFIGURATIONS UTC UNISONIC TECHNOLOGIES CO., LTD. 1 QW-R105-005,A UTC TL074 SCHEMATIC DIAGRAM LINEAR INTEGRATED CIRCUIT ABSOLUTE MAXIMUM RATINGS(Ta=25C ) PARAMETER Supply Voltage (note 1) Input Voltage (note 2) Differential Input Voltage (note 3) Power Dissipation Output Short-Circuit Duration (Note 4) Operating Free Air Temperature Storage Temperature NOTES: SYMBOL Vcc Vi Vid Ptot Toper Tstg VALUE +-18 +-15 +-30 680 Infinite 0 to 70 5 to 150 UNIT V V V mW C C 1. All voltage values, except differential voltage, are with respect to the zero reference level (ground) of the supply voltages where the zero reference level is the midpoint between Vcc- and Vcc+. 2. The magnitude of the input voltage must never exceed the magnitude of the supply voltage or 15 volts, whichever is less. 3. Differential voltages are at the non-inverting input terminal with respect to the inverting input terminal. 4. The output may be shorted to ground or to either supply. Temperature and/or supply voltages must be limited to ensure that the dissipation rating is not exceeded. UTC UNISONIC TECHNOLOGIES CO., LTD. 2 QW-R105-005,A UTC TL074 specified) LINEAR INTEGRATED CIRCUIT SYMBOL Vio 3 10 13 UTC TL074C ELECTRICAL CHARACTERISTICS( Vcc=+-15V, Ta=25C, unless otherwise PARAMETER Input Offset Voltage(Rs=50), Ta=25C Tmin<=Ta<=Tmax MIN TYP MAX UNIT mV Temperature Coefficient of Input Offset Dvio 10 |I ae V / Voltage Input Offset Current* Iio 5 100 pA Ta=25C 10 nA Tmin<=Ta<=Tmax Input Bias Current* Iib 30 200 pA Ta=25C 20 nA Tmin<=Ta<=Tmax Input Common Mode Voltage Vicm +-11 -12~+15 V Vopp Output Voltage Swing(RL=10k) 10 12 V Ta=25C, RL=2k, 12 13.5 Ta=25C, RL=10k 10 Tmin<=Ta<=Tmax, RL=2k 12 Tmin<=Ta<=Tmax, RL=10k Avd Large Signal Voltage Gain(RL=2k, Vo=+25 200 V/mV 10V) Ta=25C 15 Tmin<=Ta<=Tmax GBP 2 3 MHz Gain Bandwidth Product(Ta=25C, RL=10k, f=100kHz, Vin=10mV, CL=100pF) 1012 Input Resistance Ri CMR dB Common Mode Rejection Ratio(RS=50) 70 86 Ta=25C 70 Tmin<=Ta<=Tmax SVR dB Supply Voltage Rejection Ratio(RS=50) 70 86 Ta=25C 70 Tmin<=Ta<=Tmax Supply Current( no load) Icc mA 1. 4 2. 5 Ta=25C 2.5 Tmin<=Ta<=Tmax V01/V02 120 dB Channel Separation(Av=100, Ta=25C) Output Short-circuit Current Ios mA 10 40 60 Ta=25C 10 60 Tmin<=Ta<=Tmax SR 8 13 Slew Rate(Vi=10V, RL=2k, CL=100pF, V/s Ta=25C, unity gain) tr 0.1 Rise Time(Vi=20mV, RL=2k, CL=100pF, s Ta=25C, unity gain) Kov 10 % Overshoot Factor(Vi=20mV, RL=2k, CL=100pF, Ta=25C, unity gain) Total Harmonic Distortion(Av=20dB, f=1kHz THD 0.01 % RL=2k, CL=100pF, Ta=25, Vo=2Vpp) Phase Margin 45 Degrees en 15 Equivalent Input Noise Voltage(RS=100, f=1KHz) *The Input bias currents are junction leakage currents, which approximately double for every 10C increase in the junction temperature. UTC UNISONIC TECHNOLOGIES CO., LTD. 3 QW-R105-005,A UTC TL074 specified) LINEAR INTEGRATED CIRCUIT SYMBOL Vio 3 6 7 UTC TL074AC ELECTRICAL CHARACTERISTICS( Vcc=+-15V, Ta=25C, unless otherwise PARAMETER Input Offset Voltage(Rs=50), Ta=25C Tmin<=Ta<=Tmax MIN TYP MAX UNIT mV Temperature Coefficient of Input Offset Dvio 10 V/C Voltage(Rs=50) Input Offset Current* Iio 5 100 pA Ta=25C 4 nA Tmin<=Ta<=Tmax Input Bias Current* Iib 20 200 pA Ta=25C 20 nA Tmin<=Ta<=Tmax Input Common Mode Voltage Vicm +-11 -12~+15 V Vopp Output Voltage Swing(RL=10k) 10 12 V Ta=25C, RL=2k, 12 13.5 Ta=25C, RL=10k 10 Tmin<=Ta<=Tmax, RL=2k 12 Tmin<=Ta<=Tmax, RL=10k Avd Large Signal Voltage Gain(RL=10k, Vo=+50 200 V/mV 10V) Ta=25C 25 Tmin<=Ta<=Tmax GBP 2 3 MHz Gain Bandwidth Product(Ta=25C, RL=10k, CL=100pF) 1012 Input Resistance Ri CMR dB Common Mode Rejection Ratio(RS=50) 80 86 Ta=25C 80 Tmin<=Ta<=Tmax SVR dB Supply Voltage Rejection Ratio(RS=50) 80 86 Ta=25C 80 Tmin<=Ta<=Tmax Supply Current( no load) Icc mA 1. 4 2. 5 Ta=25C 2.5 Tmin<=Ta<=Tmax V01/V02 120 dB Channel Separation(Av=100, Ta=25C) Output Short-circuit Current Ios mA 10 40 60 Ta=25C 10 60 Tmin<=Ta<=Tmax SR 8 13 Slew Rate(Vi=10V, RL=2k, CL=100pF, V/s Ta=25C, unity gain) tr 0.1 Rise Time(Vi=20mV, RL=2k, CL=100pF, s Ta=25C, unity gain) Kov 10 % Overshoot Factor(Vi=20mV, RL=2k, CL=100pF, Ta=25C, unity gain) Total Harmonic Distortion(Av=20dB, f=1kHz THD 0.01 % RL=2k, CL=100pF, Ta=25C, Vo=2Vpp) Phase Margin 45 Degrees en 15 Equivalent Input Noise Voltage(RS=100, f=1KHz) *The Input bias currents are junction leakage currents, which approximately double for every 10C increase in the junction temperature. UTC UNISONIC TECHNOLOGIES CO., LTD. 4 QW-R105-005,A UTC TL074 specified) LINEAR INTEGRATED CIRCUIT SYMBOL Vio 1 3 5 UTC TL074BC ELECTRICAL CHARACTERISTICS( Vcc=+-15V, Ta=25C, unless otherwise PARAMETER Input Offset Voltage(Rs=50), Ta=25C Tmin<=Ta<=Tmax MIN TYP MAX UNIT mV Temperature Coefficient of Input Offset Dvio 10 |I ae V / Voltage(Rs=50) Input Offset Current* Iio 5 100 pA Ta=25C 4 nA Tmin<=Ta<=Tmax Input Bias Current* Iib 20 200 pA Ta=25C 20 nA Tmin<=Ta<=Tmax Input Common Mode Voltage Vicm +-11 -12~+15 V Vopp Output Voltage Swing(RL=10k) 10 12 V Ta=25C, RL=2k, 12 13.5 Ta=25C, RL=10k 10 Tmin<=Ta<=Tmax, RL=2k 12 Tmin<=Ta<=Tmax, RL=10k Avd Large Signal Voltage Gain(RL=10k, Vo=+50 200 V/mV 10V) Ta=25C 25 Tmin<=Ta<=Tmax GBP 2 3 MHz Gain Bandwidth Product(Ta=25C, RL=10k, CL=100pF) 1012 Input Resistance Ri CMR dB Common Mode Rejection Ratio(RS=50) 80 86 Ta=25C 80 Tmin<=Ta<=Tmax SVR dB Supply Voltage Rejection Ratio(RS=50) 80 86 Ta=25C 80 Tmin<=Ta<=Tmax Supply Current( no load) Icc mA 1. 4 2. 5 Ta=25C 2.5 Tmin<=Ta<=Tmax V01/V02 120 dB Channel Separation(Av=100, Ta=25C) Output Short-circuit Current Ios mA 10 40 60 Ta=25C 10 60 Tmin<=Ta<=Tmax SR 8 13 Slew Rate(Vi=10V, RL=2k, CL=100pF, V/s Ta=25C, unity gain) tr 0.1 Rise Time(Vi=20mV, RL=2k, CL=100pF, s Ta=25C, unity gain) Kov 10 % Overshoot Factor(Vi=20mV, RL=2k, CL=100pF, Ta=25C, unity gain) Total Harmonic Distortion(Av=20dB, f=1kHz THD 0.01 % RL=2k, CL=100pF, Ta=25C, Vo=2Vpp) Phase Margin 45 Degrees en 15 Equivalent Input Noise Voltage(RS=100, f=1KHz) *The Input bias currents are junction leakage currents, which approximately double for every 10C increase in the junction temperature. UTC UNISONIC TECHNOLOGIES CO., LTD. 5 QW-R105-005,A UTC TL074 LINEAR INTEGRATED CIRCUIT UTC UNISONIC TECHNOLOGIES CO., LTD. 6 QW-R105-005,A UTC TL074 LINEAR INTEGRATED CIRCUIT UTC UNISONIC TECHNOLOGIES CO., LTD. 7 QW-R105-005,A UTC TL074 LINEAR INTEGRATED CIRCUIT UTC UNISONIC TECHNOLOGIES CO., LTD. 8 QW-R105-005,A UTC TL074 LINEAR INTEGRATED CIRCUIT PARAMETER MEASUREMENT INFORMATION TYPICAL APPLICATIONS UTC UNISONIC TECHNOLOGIES CO., LTD. 9 QW-R105-005,A |
Price & Availability of UTCTL074
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |